8.
Operation
WARNING DANGER
THE OPERATOR OF THIS SHREDDING
TRUCKLOADER IS RESPONSIBLE FOR ACCIDENTS
OR HAZARDS OCCURRING TO HIMSELF, OTHER
PEOPLE OR THEIR PROPERTY.
A. Starting the Engine
1. Check oil level before starting the engine.
2. Turn fuel shut-off valve to “open”.
3. Put choke control to “choke” position.
4. Move throttle control to “fast”.
5. Push on / off electrical rocker switch located on the
left side of the engine to “on” position.
6. Grasp rope handle. Pull slowly until resistance is felt,
then pull rapidly to start engine.
7. Let engine warm up. Slowly adjust choke toward
“run” position.
B. Vacuuming
1. With machine fully assembled and running, hold the
handles of the intake nozzle and move intake nozzle
in sweeping motions over debris. Or rotate flange
90 degrees, put nozzle on the ground and rake the
debris in the direction of the nozzle opening.
2. Move nozzle close to debris, but do not block airflow
into the nozzle.
3. To increase hose life, periodically rotate flange
assembly (720101.17) and reposition nozzle, so the
hose will wear evenly.
WARNING DANGER
FUEL IS EXTREMELY FLAMMABLE. HANDLE IT WITH
CARE. KEEP AWAY FROM IGNITION SOURCES. DO
NOT SMOKE WHILE FUELING
YOUR EQUIPMENT.
WARNING DANGER
ENGINE EMITS CARBON MONOXIDE. DO NOT
OPERATE OR REFUEL IN ENCLOSED AREA.
G. Use of Lifting Lug
Little Wonder Shredding TruckLoader is supplied with
convenient Lifting Lug that can be used when you need
to move the unit. This Lug can hold weight up to a total
of 500lbs.
H. Liner Exchange
Little Wonder Shredding TruckLoader is equipped with a
replaceable liner in two sections (#720215 and #720216).
In order to replace the liner you will need the following
tool:
5/32” Allen wrench, Tapered pin alignment tool, and
7/16” hex socket wrench.
Liner exchange procedure:
1. Remove Front Plate assembly (720211.10)
2. Remove Impeller and Talon Ring.
3. Remove bolts that attach existing liner to he housing,
using above specified tools, and remove worn parts.
4. Hold replacement liner halves, and slip them into the
housing.
5. Position both pieces in place.
6. Align holes of the liner and housing using tapered
alignment pin, starting from the holes closest to the
liner’s seam.
7. Attach both pieces of the liner to the housing (one
hole at a time) with 12 bolts, washers and nuts (6 per
liner half, #310501, 64163-03, 310502). Insert bolt
from, the inside of the liner, and attach washer and
nuts from the outside of the housing.
I. Put Oil in Engine Before Starting
1. Little Wonder recommends using SAE 30 Oil.
The use of multi- viscosity oil will result in high oil
consumption and possible engine damage.
2. Add gasoline to the fuel tank, and you are ready to
start.
See Engine Operating & Maintenance instructions for
more detail description of type and amount of oil and
gasoline used.
WARNING DANGER
HANDLE FUEL WITH CARE. IT IS HIGHLY
FLAMMABLE. FUELING A HOT ENGINE OR NEAR
AN IGNITION SOURCE CAN CAUSE A FIRE AND
RESULT IN SERIOUS PERSONAL INJURY AND/ OR
PROPERTY DAMAGE.
WARNING DANGER
DO NOT USE OR SERVICE THE UNIT WHEN IT’S
SUSPENDED FROM THE LIFTING LUG.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels